Snorkel S3246 CE Bedienungsanleitung PDF herunterladen (Seite 17)

Chapter 4 – Safety Devices

S2646/3246 – 0410063EE 13

Guardrails

The guardrail system includes a top rail, mid rail, and

toeboards around the sides of the platform (refer to Fig-

ure 4.6).

Figure 4.6 – Platform

An entry gate allows for access to the platform for load-

ing work materials. The gate is part of the guardrail sys-

tem and must be securely fastened after loading and

entering the platform.

Horn

The horn may be used to warn personnel on the ground.

The horn is operational when the machine is set up for

operation from the upper controls.

Tilt Alarm

An alarm will sound if the aerial platform chassis is out of

level more than two degrees side-to-side or four degrees

front-to-rear when the platform is raised.

ADanger

The aerial platform can tip over if it becomes un-

stable. Death or serious injury will result from a tip-

over accident. Do not drive or position the aerial

platform for elevated use near any drop-off, hole,

slope, soft or uneven ground, or other tip-over haz-

ard.

Completely lower the platform and then drive to a level

surface when the tilt alarm sounds.

The tilt alarm is for added protection and does not justify

operating on anything other than firm, flat, level surfaces.

Overload Protection

When the load in the platform is near or at rated capac-

ity, an alarm will sound and the red light on the upper

controls (refer to Figure 4.7) will flash.

Figure 4.7 – Upper Controls

The alarm and light warn the operator that the platform is

close to becoming overloaded. All functions remain fully

operational.

ADanger

The aerial platform can tip over if it becomes un-

stable. Death or serious injury will result from a tip-

over accident. Do not exceed the capacity values

indicated on the platform rating placard.

If the platform is fully lowered and is overloaded, when it

is elevated just past 1.8 m (6′), a control module will stop

the lift and drive functions and the alarm will sound and

the warning light will flash. The platform can still be low-

ered to remove the excess load.

If the platform is elevated just past 1.8 m (6′) and material

is added to the platform overloading it, a control module

will stop the lift, drive and lower functions and the alarm

will sound and the warning light will flash. In this case,

remove the load in excess of rated capacity and cycle

the emergency stop button at the upper controls to re-

turn to normal operation.

Flashing Light

An optional red or amber flashing light may be located at

the rear of the aerial platform. The flashing light warns

personnel that the aerial platform is in the area.

The light flashes at about one flash per second when the

machine is set up for operation from the upper controls.

Toeboard

Top Rail

Mid Rail

Entry Gate

Overload Warning Light

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Snorkel S3246 CE Bedienungsanleitung Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Spezialmaschinen Snorkel S3246 CE