Snorkel S3246 CE Bedienungsanleitung PDF herunterladen (Seite 40)

Chapter 9 – Operation

36 S2646/S3246 – 0410063EE

If the platform is fully lowered and is overloaded, when it

is elevated just past 1.8 m (6′), a control module will stop

the lift and drive functions and the alarm will sound and

the warning light will flash. The platform can still be low-

ered to remove the excess load.

If the platform is elevated just past 1.8 m (6′) and material

is added to the platform overloading it, a control module

will stop the lift, drive and lower functions and the alarm

will sound and the warning light will flash. In this case,

remove the load in excess of rated capacity and cycle

the emergency stop button at the upper controls to re-

turn to normal operation.

Extending

The platform can be extended and securely locked into

position. Use the following procedure to extend or retract

the platform to full or half extension.

ACaution

The extension deck is free to move when the pins

are disengaged. Personal injury may result from

extending the platform deck while the aerial plat-

form is on a slope. Do not attempt to extend or re-

tract the platform unless the aerial platform is on a

level surface.

1. Push down on the handle on each side of the front of

the platform (refer to Figure 9.4).

Figure 9.4 – Platform

2. Stand on the main deck of the platform, facing the

front of the platform, and push forward while holding

the handles down to extend the deck.

3. Release the handles and make sure the pins are

engaged in the holes when the platform is extended

to lock it in place.

ACaution

The extension deck is free to move when the pins

are disengaged. Make certain the pin is engaged

when the deck is extended in the working position

and when it is stowed.

4. Try to move the rails back and forth to make sure the

platform extension deck is locked in position. The

handle should angle upward when the extension deck

is locked in position.

Swing-Down Rails

The platform rails may be lowered approximately 63.5

cm (25″) to fit the machine under low height obstructions

or for transporting.

AWarning

The potential for an accident increases when the

swing-down rails are lowered. Death or serious in-

jury can result from such accidents. Do not elevate

the platform with the swing-down rails lowered. Use

extreme care when moving the aerial platform

while the swing-down rails are lowered.

Use the following procedure to lower the platform guard-

rails.

1. Remove the pin from the platform gate. Fasten the

gate to the mid rail on the right side of the platform

(refer to Figure 9.5).

Figure 9.5 – Platform Gate

2. Remove the pin that connects the upper controls to

the guardrails (refer to Figure 9.6). Lay the upper con-

trols on the floor of the platform.

Handle

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Snorkel S3246 CE Bedienungsanleitung Seite 40

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Spezialmaschinen Snorkel S3246 CE