Snorkel S3246 CE Bedienungsanleitung Seite 28

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 60
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 27
Chapter 8 – Prestart Inspection
24 S2646/3246 – 0410063EE
Figure 8.11 – Lower Controls
2. At the lower controls, pull the emergency stop switch
outward to the on position.
3. Insert the key into the control selector switch and
turn the switch to the lower controls position.
ADanger
Pinch points may exist between moving compo-
nents. Death or serious injury will result from be-
coming trapped between components, buildings,
structures, or other obstacles. Make sure all person-
nel stand clear of the aerial platform while perform-
ing the prestart inspection.
Test the operation of the platform raise/lower switch in
both directions.
Place the battery disconnect switch in the off position.
The platform should not raise or lower with the discon-
nect in this position.
Emergency Stop
Push the emergency stop button in to turn off the electri-
cal power. The lower control functions should not operate
with the emergency stop in this position.
Lowering Alarm and Interrupt
Raise the platform approximately 3 m (10). Lower the
platform and make sure the alarm sounds. The platform
should stop lowering when it reaches about 1.5 m (5).
Release the raise/lower toggle switch to reset the lower-
ing function. Wait for 5 seconds and then push the joy-
stick forward to continue lowering.
Pothole Protector Interlock
Perform this test using the lower controls.
1. Stow the aerial platform on a smooth, flat, level con-
crete slab.
2. Remove all persons and materials from the platform.
Tires and Wheels
Visually inspect the tires (refer to Figure 8.9). They should
be smooth without any cuts, gouges, or missing rubber
that might affect aerial platform stability.
Figure 8.9 – Tires and Wheels
Check the wheel lug nuts to see that none are missing,
damaged, or loose.
Ground Strap
Make certain the ground strap (refer to Figure 8.10) is
securely fastened to the chassis. It should be long enough
to contact the ground surface to eliminate static electric-
ity from the machine.
Figure 8.10 – Rear of Chassis
Lower Control Station
With no personnel in the platform, test the operation of
each control from the lower control station (refer to Fig-
ure 8.11).
Operating Controls
Use the following procedure to operate the machine from
the lower controls.
1. Turn the battery disconnect switch on.
Ground Strap
Emergency
Stop Button
Platform Raise/Lower Switch
Control Selector Switch
Seitenansicht 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare